Sysprep: resolve the error: Windows could not finish System

Symptom

After running a sysprep the following error is displayed during reboot.

Windows could not complete the system configuration. To attempt to resume configuration, restart the computer.

Resolution

When the message appears, press Shift + F10 to open a DOS prompt.

On the Hyper-V console, use the virtual keyboard of the host

Enter the following commands to launch the Windows Setup Wizard:

cd oobe
msoobe

Complete the wizard by configuring Windows, when you have finished, restart the computer it should continue to boot normally.


How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

We are sorry that this post was not useful for you!

Let us improve this post!



Related Posts


WDS – Configure Multiple PXE Servers
Presentation This article describes how to use multiple WDS servers on a single network. This solution is undocumented by Microsoft, it is possible to have multiple WDS servers active on the same network. To enable this feature, it is necessary to ad

MDT: Install updates with WSUS
Presentation In this tutorial, I'll explain how to enable Windows updates to a WSUS server when deploying an image with MDT. Enable updates Open the properties of an installation sequence, go to the Task Sequence << 1 >> tab and activate

Install and use the Admin Center on Windows 10
Presentation In this tutorial, we will see how to install the Admin Center on a computer running Windows 10. The Admin Center is the new name of the Honolulu Project that allows the administration of servers from the Windows Server 2008R2 version and

Leave a Comment