MPIO: Enable Path Check

By default, this feature is not enabled, the paths are checked during a problem.

Enable path verification

Open a PowerShell command prompt and enter the following command to check the status of PathVerificationState:

To enable path checking, enter the following command:

Restart the server to take account of the configuration.





Related Posts


Configure a SAN disk on Windows

Introduction In this tutorial, we will see how to configure a SAN-type disk to present to a Windows server. SAN type disks are LUNs / Volume that are presented in FC / iSCSI / SAS. They are often host

EMC Unity 300: Adding an FC Host

In this tutorial, we will see how to configure a host on an EMC Unity 300 array. Before you begin, the server must be plugged into the array either directly attached or through fabrics. If you are plu

MPIO: Installation and configuration

MPIO or MultiPath I / O is a Windows feature that allows multiple path support for storage. MPIO addresses two issues: performance and reliability. The majority of storage bays have two controllers fo