Sysprep: resolve the error: Windows could not finish System

Symptom After running a sysprep the following error is displayed during reboot. Resolution When the message appears, press Shift + F10 to open a DOS prompt. On the Hyper-V console, use the virtual keyboard of the host Enter the following commands to launch the Windows Setup Wizard: Complete the wizard by configuring Windows, when you …

Read moreSysprep: resolve the error: Windows could not finish System

Windows Server Deduplication: reclaim disk space after deleting files

Presentation On a Windows Server volume where deduplication is enabled, when deleting files, the recovered space is not necessarily available immediately. In this article we will see how to recover the space immediately. Recover disk space Open a PowerShell command prompt as an administrator and enter the following command: Adapt the letter of the Volume …

Read moreWindows Server Deduplication: reclaim disk space after deleting files

MPIO: Enable Path Check

By default this feature value is not enabled, the paths are checked during a problem. Open a PowerShell command prompt and enter the following command to check the status of PathVerificationState: Get-MPIOSetting   To enable path checking, enter the following command: Set-MPIOSetting -NewPathVerificationState Enabled Restart the server to take account of the configuration.

DirectAccess – Installation – Configuration in Windows Server 2016/2019

DirectAccess is a feature available with the Remote Access role, which allows you to set up an automatic connection solution to the corporate network for mobile computers or for small remote sites. Unlike a VPN, the connection is initiated directly by a service on the remote computer, which allows for similar behavior if the workstation …

Read moreDirectAccess – Installation – Configuration in Windows Server 2016/2019